Remote Car Battery Disconnect Switch System - kill your car power system with a remote controller now.
Handy easy & simple - this Remote Control Electromagnetic Battery Switch allows you to move the trigger from under the hood to your hand
Turn on the battery before you start the engine (160 feet remote distance)
Do not turn off the battery when your engine is working
This remote battery switch is only for battery on / off, it can't start your engine
Outer Antenna makes signal further and stronger
Default off design, if the battery were dead ,the device default to closed condition
Product Name: Automotive Power Supply Main Switch
Product material: ABS+copper+silver
Battery model: CR2016 * 1 (one battery per remote control) (shipped with built-in battery)
Battery capacity: 75mAh
Working voltage: DC11-15V
Rated current: 250A
Starting current: 450A (less than ten seconds)
Standby current: 0.005A
Switch size: 45 * 45 * 45mm
Instructions for use
Working voltage:
12V, working voltage range 11-15V
The 12V and 24V remote power off switches are not compatible. For a single battery, choose 12V. For most cars, small trucks, agricultural vehicles, etc., choose the corresponding voltage.
Switching power consumption:
When this switch is in standby mode, it consumes 5 milliamperes of electricity. The new car's factory power consumption is around 20 milliamperes, which is even more energy-saving than the new car. When the switch is in operation, it consumes about 3W of power. When the car door is locked, use the remote control to turn off the main power.
Operating instructions
Installation method 1: Connect the thin red wire to the positive pole of the battery, and the thin black wire to the negative pole of the battery. This supplies power to the switch, and the remote control switch has very little power. 2: The two large terminals on the relay switch are the main switch. One incoming line, one outgoing line, regardless of sequence, only for on/off function. 3: When controlling the on/off of the negative electrode, one large terminal is connected to the negative electrode incoming line of the battery, and another large terminal is connected to the negative electrode outgoing line of the battery (the same applies to the positive electrode)
Packaging List
Remote control * 2
Main power switch * 1
Copper nose * 1
Battery clip * 2
Adapting copper plate * 1
matters needing attention
1: After installation, the relay switch will increase battery power consumption when turned on. When leaving the car, it is necessary to use the remote control to turn off the main power in a timely manner to avoid prolonged power consumption, which may cause power loss and inability to start. 2: Due to the fact that cutting off the entire vehicle's power supply will cause the alarm, onboard computer, and other devices to be powered off and unable to function, the vehicle needs to be powered off without any impact before it can be used. 3: When driving normally, do not disconnect the relay switch to prevent the generator voltage from increasing and damaging the car's electrical components.
